V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Install the rubber tabs from the kit over the four installed screws as follows:
-
Align the rubber tabs (1) edge to edge with the lining mat.
-
Compress the rubber tab (2) slightly to align in the cut-out.
-
Align the rubber tab (3) so that the lower edge is edge to edge with the lining mat. Cut off the section protruding over the lining mat. (Do not cut
off an excessive amount).
Applies to cars with lining mats with one perforation
-
Install a new lining mat.
Illustration A applies to the V70
Illustration B applies to the XC70
-
If necessary, cut away the area (1) around the screw heads, so that the screws are accessible.
Securing the ball holder