V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Mark the hole for the connector bracket for drilling as illustrated.
-
Pre-drill with a smaller drill bit. Enlarge the hole with a Dia. 6.5 mm (1/4")" drill bit.
-
Remove any swarf. Rust-proof the edges of the holes.
-
Take out the screw, washer, nut and bracket from the kit.
-
Place the bracket over the drilled hole with the text (1) facing backwards. Mark out to cut off the corner of the bumper cover as illustrated.
-
Cut off the corner.
-
Fit the bracket (with the text (1) facing backwards), with the screw, washer and nut. Do not tighten the bracket yet.
-
Place the connector on the bracket as illustrated.
-
Adjust the position of the bracket with the connector and tighten the screw/nut correctly.