V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
the control arms. Use new screws and new nut. Tighten the front screws. Tighten to 65 Nm. Angle tighten 90 degrees. Use bevel protractor 951
2050. Tighten the rear screw. Tighten to 105 Nm. Angle-tighten 90 degrees
-
the anti-roll bar. Tighten to 60 Nm
-
the right-hand engine mounting. Tighten the screws. Tighten to 65 Nm. Angle-tighten 60 degrees
-
the mounting for the heated oxygen sensor (HO2S) wiring
-
the engine pad.
Install new pipe/hose holders.
Installing the subframe
-
Position the sub-frame on a lifting table
-
Carefully lift the subframe
-
Locate the control arms on the ball joints and the steering gear on its mountings
-
Remove the hook (999 5045) that is holding the steering gear
-
Lift the sub-frame up completely
-
Reinstall the engine block heater (if applicable).
