V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Lifting the sub-frame
-
Lift the sub-frame up completely.
-
At the same time locate the mounting screws for the steering gear the sub-frame and, on right-hand drive cars, the screw for the collision protection
system.
-
Install the sub-frame brackets loosely together with the washers.
-
Install the four screws for the sub-frame. Use new screws. Do not tighten yet.
-
First tighten the screws on the left side of the sub-frame. Tighten to 105 Nm. Angle tighten 120 degrees. Then tighten the right-hand side to the
same values as the left side.
-
Finally tighten the screws for the brackets on both sides. Tighten to 50 Nm.
-
Install the engine block heater (if applicable) on the left front mounting for the subframe.
CAUTION: Tighten the left-hand side first. The sub-frame guides are on the left-hand side.
Installing the nuts and screw for the steering gear
