V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Disconnect the wiring harness from the sub-frame.
Remove the exhaust pipe bracket and twist to one side.
Unhook the silencer from the rubber suspension.
Position a lifting table (minimum capacity 500 kg) under the sub-frame so that the engine/transmission unit cannot twist or slide.
Apply the lifting table so that the load is taken off the sub-frame screws.
Remove the sub-frame screws together with accompanying brackets and washers.
Carefully lower the engine/transmission unit approximately 90 mm (3.54")
Removing the sub-frame bushings
Use tool 999 5457.
Install
-
the counterhold (1) on the upper side of the bushing.
-
the cutting sleeve (3) and the screw with nut (6) from underneath.
Tighten the cutting sleeve until it stops against the counterhold. The cutting sleeve is now fixed in the bushing.
Remove the counterhold.
