V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Cut along the inside of the flange (1), on the underside of the bumper so that the flange remains in the bumper.
-
After cutting, smooth off the edges using a file.
Only applies if the car is equipped with mouldings
-
In addition, cut out the moulding in accordance with the markings (2).
Illustration B only applies to the V70R up to and including model year 2004
-
Apply masking tape on the outside of the exhaust pipe clip to avoid damage from the saw. Leave the masking tape in place during installation.
-
Cut along the marked raised area and remove the cut-out area.
-
After cutting, smooth off the edges using a file.
-
Clean away any underseal and dirt from the surfaces between the tow hitch and the bodywork.
The illustration shows how the tow hitch and its components are assembled and installed on the body.
Carry out on both sides, the right-hand side is illustrated
-
Install the screws (7, 8) from underneath the brackets (4:1, 5:1, 9:1), including the sleeves (6), without tightening. The arrows on the brackets (4:1,
5:1, 9:1) must point towards the centre of the car.
