V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Tighten the screws (2) and the nuts (3). Tighten to 136 Nm (102 lbf.ft) on both sides.
-
Wait at least five minutes, so that the joint has time to set. Then tighten the screws (8) on both sides, a quarter turn (angle tighten 90°).
NOTE: Torque tightened screws that have been removed must not be re-used.
-
Underseal the car.
Finishing work
Illustration A applies to the V70
-
Only applies if the car is equipped with mouldings: Reinstall the mouldings (3) on the expander clips. Press the mouldings into place.
-
If the guide lugs (4) and clips (5) have loosened - reinstall them.
-
Applies to cars with parking assistance: Lift up the bumper in position. Pull the cable for the sensors through the hole for the bumper's guide, and
pull the cable in from the inside.
-
Reinstall the bumper by pressing it forwards. Ensure that the four screws protruding from the bumper align with the holes in the car.
-
Before the bumper is completely installed, slide the top edge (1) into the grooves. Then slide the bumper fully in.
-
Check that the guide lug (4) and clip (5) are centred with the hole in the wheel arch lining.