V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Clean the mating surfaces for the spoiler against the boot lid. Use a mixture of 30% windscreen washer fluid and 70% water
-
Wipe dry
-
Take the tape from the kit. Remove the thin protective film. Leave the thick film in place. Press the tape firmly against the mating surfaces.
Note! The tape must cure for 24 hours at a minimum of 20°C (68°F) before painting.
-
Install the foam covering on the underside of the spoiler, in the oval depression
Spray paint according to "Touch up spraying".
-
Take the sheet containing the drilling templates from the kit. Cut out the drilling templates.
Illustration A
-
Position the left and right-hand drilling templates against the rear corners of the boot lid. See the illustration
-
Ensure that the templates exactly cover the edges of the boot lid. Loosely secure the templates using tape
-
Measure the distance between the hole markings on the cardboard templates. Use a soft tape measure that follows the shape of the boot lid. The
distance between the hole markings must be 1063.2 mm (41 55/64").
Note! The radian measure must be measured.
