V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Install the ABS line in its clips.
Lower the car.
Tighten brake pipes on brake hose to 17 Nm.
Install the brake pipe in the ABS hydraulic modulator
Tighten to 17 Nm.
Install:
-
the brake pipe in its holder. Open the holder
-
the integrated relay / fusebox.
-
the Air Cleaner (ACL) housing.
Front-rear brake pipe to the rear junctions, replacing
Clean around the brake pipe on the ABS hydraulic modulator. Remove the brake pipe from the ABS hydraulic modulator and holder
Open the holder.
Remove the brake pipe from its clips by the side member
Straighten the brake pipe by the ABS hydraulic modulator.
Note: The new brake pipe must be bent into the correct shape when installing. This is important otherwise the pipe may be subject to stresses when it
is in place.
Remove the brake pipe from its clips
Raise the car
Remove the left front wheel.
