V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Tighten the screws. Tighten to 25 Nm.
Install the cross member
Vacuum system, checking See: Testing and Inspection.
Use a new nut. Tighten to 80 Nm.
Final check
Check that the servo is functioning during braking.
Power Brake Booster, Replacing, L.H.D
Power brake booster, replacing
Preparation
Disconnect the battery lead
See Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting.
Removal
Preparations for removing the power brake booster
Switch off the ignition.
Remove the cross member
See Brake fluid reservoir, replacing, L.H.D See: Hydraulic System/Brake Fluid Reservoir/Service and Repair/Brake Fluid Reservoir, Replacing, L.H.D.
(On 5 cylinder engines). Remove the screws and nuts from the engine mounting. Lift out the cross member.
Remove the air cleaner (ACL) housing
See Brake pipe master cylinder / ABS unit, replacing, B5254T2 See: Hydraulic System/Brake Hose/Line/Service and Repair/Brake Pipe Master Cylinder