V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Note! Oil the center screw before installation.
Press the variable valve timing unit/timing gear pulley onto the camshaft. Install the center screw (1) that holds the variable valve timing unit to the
camshaft. Do not tighten yet.
Slacken off, but do not remove the screws (2) which secure the timing gear pulley to the variable valve timing unit.
Position the upper timing cover.
Turn the timing gear pulley so that the screws at the oval holes are in the limit position. Continue turning clockwise until the timing gear pulley's marking
is 1 tooth before the marking on the upper timing cover.
Check that the timing gear pulley is still in the limit position in the oval holes.
Tighten the center screw (1) in the VVT unit to 120 Nm.
Check that the variable valve timing unit does not rotate when tightening. Install the center plug and tighten to 35 Nm.
Install the belt pulley on the exhaust camshaft: Install the belt pulley on the intake camshaft with three screws; do not tighten yet.
Check that the markings on the belt pulley and the upper timing cover align.
Installing the timing belt
Install the belt in the following order:
