V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
the wheel.
-
the engine stabilizer brace. Tighten the screws at the suspension turrets. Tighten to 50 Nm. Tighten the engine bracket screw. Tighten to 80 Nm
-
the cable to the battery negative terminal.
Checking the engine
Test drive the car to check the function of the engine.
Rear camshaft seal
The following components must be removed when replacing the rear camshaft seal:
-
the inlet hose between the air cleaner (ACL) and throttle body (TB)
-
the crankcase ventilation hose from the inlet hose
-
place the air cleaner (ACL) cover to one side
-
the cover over the ignition coils
-
the upper torque rod bracket
-
the camshaft position sensor (CMP) housing and trigger wheel.
Replacing the rear camshaft seal