V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Note! When installing a new cylinder head, the valve clearance must be set. See Valve clearance See: Cylinder Head Assembly/Valve
Clearance/Adjustments/Valve Clearance.
Lubricate the valve guide wells.
Install all the valve lifters.
Note! Make sure that the lifters end up in the same position as before.
Lubricate the camshaft bearing seats.
Install the intake camshaft. Ensure that the groove at the rear edge of the camshaft is above an imaginary center line.
Position the exhaust camshaft. Ensure that the groove at the rear edge of the camshaft is below an imaginary center line.
Applying liquid gasket
Wipe the oil film off the mating surfaces on the camshaft cover and cylinder head.
Install new O-rings around the spark plug wells at the cylinder head.
Apply liquid gasket 116 1059 on the camshaft cover.
Use roller 951 2767 Roller See: Tools and Equipment/951 2767 Roller.
The surface must be completely covered without any excess.
Caution! Make sure that no liquid gasket gets into the oil channels.
Installing the camshaft covers
