V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
the servo reservoir. Check that the hoses are correctly positioned
-
the starter motor. Tighten the screws at the transmission to 40 Nm. Tighten the screw for the support bracket. Tighten to 25 Nm. Remove the
radiator protector.
Carefully lower the fan shroud. Align it with the holes at the sides of the radiator
Tighten both the mounting screws.
Connect the engine cooling fan (FC) connectors.
Press the hose down from the expansion tank into the holder on the fan shroud.
Secure the wiring with tie straps as before.
Press the manifold absolute pressure (MAP) sensor onto the holder at the front cover plate.
Press the evaporative emission system (EVAP) valve into the holder on the fan shroud.
Turn down the air cleaner (ACL) intake manifold and locate against the sleeve connector above the air conditioning aggregate.
Install
-
the brake vacuum hose
-
the trigger wheel. Tighten to 17 Nm
-
the camshaft position (CMP) sensor housing and a new cover. Tighten to 17 Nm
-
the torque rod bracket. Tighten to 50 Nm
-
the inlet hose between the air cleaner (ACL) and throttle body (TB)
-
the crankcase ventilation hose on the inlet hose
-
the plastic nuts for the cover in fender liner
