V70 2.4 L5-2.4L VIN 61 B5244S (2001)
contaminants are completely removed before the new sealing ring is installed.
Lubricate the surface of the seal that the camshaft rotates against. Install the camshaft seal. Use drift 999 5450 PUNCH See: Tools and Equipment/999
5450 Punch.
Note! The seal is normally pressed in so that it is level with the internal beveled edge.If the shaft journal is showing signs of wear, the seal can
be pressed in 2 mm deeper by turning the drift socket.
Reinstall
Install:
-
the trigger wheel.
Tighten to 17 Nm
-
the camshaft position (CMP) sensor housing and a new cover.
Tighten to 17 Nm
-
the torque rod bracket.
Tighten to 50 Nm
-
the cover over the ignition coils
-
air cleaner (ACL) cover
-
the inlet hose between the air cleaner (ACL) and throttle body (TB)
-
the crankcase ventilation hose on the inlet hose
Check the engine compartment. Wipe the engine compartment clean.
Checking the engine
Test drive the car to check the function of the engine.
