V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Oxygen Sensor: Description and Operation
Heated Oxygen Sensors (HO2S)
Front heated oxygen sensor (HO2S)
The front heated oxygen sensor (HO2S) is used to provide the engine control module (ECM) with information about the remaining oxygen content of the
exhaust gases in front of the three-way catalytic converter (TWC). This information is used by the engine control module (ECM) so that it can
continually check the combustion so that Lambda=1. Lambda=1 is the ideal fuel-air ratio, with 14.7 kg air/1 kg fuel.
The heated oxygen sensor (HO2S) uses current control and its signal characteristic is linear. With a linear signal characteristic, the amplitude of the
signal curve is low when changing the oxygen content in the exhaust gases. The probe consists of a preheating element (see Pre-heating heated oxygen
sensors (HO2S)) and the actual lambda sensor. The lambda sensor is an oxygen sensitive ceramic body consisting of zirconium oxide. The control
module supplies power to the ceramic body, which reacts to the oxygen content of the exhaust gases. This in turn affects the signal to the Engine Control
Module (ECM). In order to determine the oxygen content in the exhaust pipe, the heated oxygen sensor (HO2S) needs reference air from the surrounding
air. This reference air reaches the heated oxygen sensor (HO2S) via the cable harness.
CAUTION: The cable harness for the heated oxygen sensors (HO2S) must not be trapped or damaged in any way. The connectors for the heated
oxygen sensors (HO2S) must not be greased under any circumstances. The oil in the grease would disrupt the reference air and the function of the heated
oxygen sensors (HO2S).
The engine control module (ECM) can diagnose the heated oxygen sensor (HO2S). For further information, see Heated oxygen sensor (HO2S)
diagnostic. VADIS can be used to read off the calculated lambda value from the heated oxygen sensor (HO2S).
Rear heated oxygen sensor (HO2S)
