volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Fuel/Emissions - ETM/Crankcase Ventilation Sys. Cleaning|Page 17456 > < Fuel/Emissions - ETM/Crankcase Ventilation Sys. Cleaning|Page 17454
Page 19
background image

-

the expansion tank and the power steering reservoir in the mounting on the spring strut turret

-

the tie strap around the power steering hose by the suspension turret

-

power steering hose and in the holder on the belt protection on the power steering pump

-

the connector with holder on the power steering pump

-

the coolant hose to the holder on the control module box

-

the holder with coolant hose to the power steering hose

Install:

-

the auxiliaries belt. Use wrench 999 7109

-

the oil dipstick pipe

-

the cold air inlet hose to the control module

-

the air duct for the air cleaner (ACL) housing.

Turn the ignition key to position 2 
Install the battery negative lead to the battery.

Note! 

The method applies to only cleaning the throttle module for the S70 1999-2000 S60 2001-2002 V70 1999-2002 5-cyl Non-turbo

Remove:

-

the battery negative lead from the battery. When removing and installing the battery leads. See: Electrical system Battery replacement

Remove:

-

the intake pipe between the front cover plate and the air cleaner.

-

the intake pipe between the air cleaner and the electronic throttle module (ETM) and put it to one side.

Fuel/Emissions - ETM/Crankcase Ventilation Sys. Cleaning|Page 17456 > < Fuel/Emissions - ETM/Crankcase Ventilation Sys. Cleaning|Page 17454