V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Carefully wipe the inside of the bore clean on both sides of the throttle disc. Wipe clean the edge of the throttle disc.
Do not use compressed air to dry the throttle module.
Cleaning the crankcase ventilation
Remove the banjo bolt from the intake manifold.
Remove the hose (1) from the banjo nipple. Remove the oil filler cap.
Blow the hose clean (1) using compressed air (2) to verify that the system is open. If the hose is blocked clean the hose using 2.0 mm diameter wire.
If air travels through to the oil filler the breather is good, no further verification or repairs are necessary.
Note!
If the hose is blocked, use a welding rod (maximum diameter 2.0 mm, approximately 250 mm long) to unblock the hose.
Clean the banjo nipple using a diameter 2.0 mm drill bit (3).
Install:
-
the hose on the banjo nipple
-
the banjo bolt with new gaskets
-
the oil filler cap.
Raise the car.
Remove the splashguard under the engine
Tighten the banjo bolt. Tighten to 24 Nm.
