V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Remove the hose with the T-nipple from the intake manifold.
Remove the protection 999 5723.
Clean the hole in the intake manifold using a 2 mm drill bit.
Remove the hose from the T-nipple. Clean the T-nipple. Use a 2 mm drill bit. Clean the hose using 2 mm wire and blow clean using compressed air.
Wipe clean the intake manifold's air duct. Install the hose on the T-nipple. Install the hose with the T-nipple to the intake manifold.
Install the protection 999 5723.
Install:
-
the electronic throttle module (ETM) with a new gasket
-
the 4 x screws for the electronic throttle module (ETM). Tighten to 10 Nm.
Remove the protection 999 5723. Install new gasket
Install the upper section of the intake manifold. Tighten the screws from the inside out alternately. Tighten to 17 Nm.