V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Installing the electronic throttle module (ETM)
Install:
-
the new electronic throttle module (ETM) with new gasket
-
the 4 bolts until they make contact.
Route the electrical cable for the electronic throttle module (ETM) behind the starter motor bracket.
Fit the bolt in the engine block. Tighten the two nuts and the bolt. Plug in the connector and install the cable tie.
Note!
If the cable was not routed behind the starter motor bracket, fasten the cable along the cable duct using two strip clamps.
Install: