V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Route the electrical cable from the electronic throttle module (ETM) behind the starter motor bracket. Fit the bolt in the engine block. Tighten the two
nuts and the bolt. Plug in the connector and install the cable tie.
Note!
If the cable was not routed behind the starter motor bracket, fasten the cable along the cable duct using two strip clamps.
Raise the car. Remove the cover from below the engine. Tighten the 4 electronic throttle module (ETM) bolts. Tightening torque 10 Nm. Install the
cover below the engine. Lower the car.
Installing the charge air pipe
Install the charge air pipe to the electronic throttle module (ETM) and intercooler. Tighten the hose clamp of the charge air pipe on the electronic throttle
module (ETM).
Plug in the two connectors of the charge air hose between the intercooler and electronic throttle module (ETM). Fit the overflow valve to the charge air
hose with the clamp.
Install: