V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Route the electrical cable for the electronic throttle module (ETM) behind the starter motor bracket.
Fit the bolt in the engine block. Tighten the two nuts and the bolt. Plug in the connector and install the cable tie.
Note!
If the cable was not routed behind the starter motor bracket, fasten the cable along the cable duct using two strip clamps.
Install:
-
intake manifold between the electronic throttle module (ETM) and air filter
-
dipstick guide tube.
Finishing work
Turn the ignition key to position 2. Connect the battery cable to the negative battery terminal.
Ordering and downloading software
Note!
After ETM reload the ECM must be upgraded.
Order and download software for ETM reload and ECM gasoline upgrade.
Finishing work
Check that no diagnostic trouble codes were stored in the control module during repair work. Test drive the car and check the functionality of the engine.
