V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Tighten to 25 Nm.
Remove the hose clip.
If the vehicle has locking brackets
Install the locking bracket (2). Tighten the screw (1). Tighten to 24 Nm.
Note!
There may be a gap (3) of a few millimeters between the pipe coupling and the power steering pump. Bend the bracket so that the twelve edged
mounting on the bracket is on the nut.
Install:
-
the auxiliaries belt. Use wrench 999 7109
-
the power steering reservoir in its mounting on the expansion tank
-
the tie strap for the power steering hose by the suspension turret
-
power steering hose in the holder on the belt protection on the power steering pump
-
the connector with holder on the power steering pump.
Install:
-
the charge air hose on the charge air cooler (CAC).
-
the screw for the charge air pipe above the engine and clamp for the power steering pump delivery line from the intake manifold.
