V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Route the electrical cable for the electronic throttle module (ETM) behind the starter motor bracket.
Fit the bolt in the engine block. Tighten the two nuts and the bolt. Plug in the connector and install the cable tie.
Note!
If the cable was not routed behind the starter motor bracket, fasten the cable along the cable duct using two strip clamps.
Raise the car.
Remove the cover from below the engine.
Tighten the 4 electronic throttle module (ETM) screws. Tightening torque 10 Nm.
Install the cover below the engine.
Lower the car.
Attach the charge air hose to the electronic throttle module (ETM) and tighten the clamp.
Installing the fan cowling
Carefully lower the fan cowling and align it with the retainers. Route the cable harness behind the retainer (3).
Tighten the two retaining bolts. Press down the hose from the expansion tank into the retainer on the fan cowling. Use cable ties (1) and (2) to