V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
the 4 screws until they make contact.
Route the electrical cable for the electronic throttle module (ETM) behind the starter motor bracket. Fit the bolt in the engine block. Tighten the two nuts
and the bolt. Plug in the connector and install the cable tie.
Note!
If the cable was not routed behind the starter motor bracket, fasten the cable along the cable duct using two strip clamps.
Raise the car. Remove the cover from below the engine. Tighten the 4 electronic throttle module (ETM) screws. Tightening torque 10 Nm. Install the
cover below the engine. Lower the car.
Attach the charge air hose to the electronic throttle module (ETM) and tighten the clamp.
Installing the fan cowling
