V70 2.4 L5-2.4L VIN 61 B5244S (2001)
opening. Use a screwdriver
-
Remove the bulb holder together with the rear view mirror and control module.
Installation
-
Connect the connector for the rear view mirror and control module
-
Reinstall the cover for the rear view mirror and control module connector
-
Connect the 2 connectors
-
Install the ground lead
-
Press the bulb holder into place
-
Install the 2 screws at the front edge.
CAUTION: Check that the microphone cable is not trapped (if applicable).
-
Install the lens.
HINT: Only certain versions of the upper electronic module (UEM) have a ground lead.
Replacing the switch for the interior lighting
Removal
-
Remove the lens.
-
Remove the bulb holder.
-
Remove the bulbs
-
Remove the screws
-
Remove the back piece from the switch
-
Detach and remove the printed circuit board and switch.Replace the switch for the sun roof.
Installation
In reverse order.
Rear view mirror, replacing
NOTE: A rear view mirror with manual function cannot be replaced with automatic anti-dazzle or vice versa. The car will store diagnostic trouble codes
(DTCs).
The upper electronic module (UEM) is integrated in the rear view mirror.
Replacing the upper electronic module (UEM), or the rear view mirror
Preparations
NOTE: Read off data from the control module before replacing the control module. Program this data back into the new control module.
Programmed data is read off via VADIS vehicle communication.
CAUTION: New software can only be ordered after the control module has been installed in the car. VADIS reads off the new control module identity
which is required to order the correct software.
Always check the control module and connector on the control module box for bent or damaged pins or sockets. This may have caused the fault.
Removing the control module