V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Detach the lateral link by installing a tensioning strap and drawing the lower link arm slightly towards the jacking point.
Slacken off the screw at the front mounting slightly. Turn the lateral link downwards.
Remove:
-
the lateral link screw at the spindle
-
the tie rod outer mounting.
Turn the tie rod upwards.
Release the retaining strap.
Removing the bushing
Install tensioner and tension the rear suspension to the normal position. See Tensioner, instructions for use, M66, TF-80SC, AW55-50/51SN, M56 See:
Service and Repair/Removal and Replacement/Tensioner, Instructions For Use
Remove the screw for the lower outer control arm mounting.
Turn out the spindle
Install:
-
Install the screw for the control arm mounting using 999 7046 Drift See: Tools and Equipment/999 7046 Drift as a spacer to keep the spindle out.
-
the hydraulic cylinder.
Use 951 2923 Hydraulic hole cylinder See: Tools and Equipment/951 2923 Hydraulic Hole Cylinder , with 999 7054 Adapter incl. 2x MC6C M6X12
See: Tools and Equipment/999 7054 Adapter Incl. 2X MC6C M6X12 , 999 7035 Sleeve See: Tools and Equipment/999 7035 Sleeve , 999 7044 Sleeve
See: Tools and Equipment/999 7044 Sleeve , 999 7045 Drift See: Tools and Equipment/999 7045 Drift and 999 7034 Connecting rod M12X400 See:
Tools and Equipment/999 7034 Connecting Rod M12X400.
Pull the bushing forwards in the direction of the vehicle.
Installation
Installing the bushing