V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Remove and hang the engine block heater (if applicable) on the left front mounting for the sub-frame.
-
Remove the fuel line for the engine block heater (if applicable) on the sub-frame from the snap fasteners.
-
Position a lifting table under the sub-frame.
-
Apply the lifting table so that the load is taken off the sub-frame screws.
-
Remove the sub-frame screws together with the accompanying brackets and washers.
-
Carefully lower the subframe approximately 50 mm.
NOTE Ensure that the steering gear screws are released from the sub-frame.
-
Remove the bracket for the heated oxygen sensor (HO2S) from the sub-frame.
-
Lower the sub-frame a further 40 mm.
Pressing out the bushings