V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Installation:
If the piston and spring do come out of the transmission, clean them with transmission fluid and re-install them with the new cover as shown here. Be
careful not to drop the piston. If it does fall, check it carefully for damage. If necessary, the piston O-ring can be replaced with the third one included in
the kit. You can not replace the piston with one from another transmission; several different length pistons are used when the transmission is calibrated
and assembled.
Once the new cover is placed in the bore, push it in using the bolt and screwdriver (this is to compress the spring). Install the new snap-ring and be sure it
is properly seated in the groove.
Remove the bolt, clean up any spilled oil, re-install the splash pan and the LF wheel.
Adaptation:
