V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Install:
-
the bracket for the pedal position sensor
-
two new lock nuts for the master cylinder. Tighten to 25 Nm.
Note! Ensure that the ball on the bracket is downwards.
Install:
-
the pedal position sensor on the bracket and on the push rod
-
the soundproofing panel.
Finishing work in the engine compartment
Remove the hose clip.
Connect the connectors to the relevant switches.
Install the torque rod. See Brake fluid reservoir, replacing See: Brakes and Traction Control/Hydraulic System/Brake Fluid Reservoir/Service and Repair
.
Install the clamp and the screw for the oil hose on the cross member mounting. Tighten to 10 Nm.
Bleed the clutch
Final check
Check the brake fluid level. Use only Volvo Genuine parts brake fluid (Volvo DOT 4+) when topping up.
Start the engine. Check that the clutch disengages when the gears are selected. Bleed the clutch if necessary.
