V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Align the ball joint in the control arm
Note: Be very careful when releasing the tension strap.
-
Release the control arm slowly using the tension strap.
Installing the ball joint
Install a new nut on the ball joint.
Note: The ball joint must not rotate. Use a Torx wrench as a counterhold so that the rubber boot is not damaged.
Tighten to 80 Nm.
Installing the brake disc
Install the brake disc.
Tighten the brake disc locating pin. Tighten to 8 Nm.
Note: Ensure that the brake disc and wheel rim hub mating surfaces are clean.
Tighten the new drive shaft screw. See Tightening torque.
Use bevel protractor 951 2050.
Installing brake calipers