V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Use extractor 999 5726 Puller See: Tools and Equipment/999 5726 Puller.
Tap in the extractor for the primary shaft seal.
Note! The screw and socket must be unscrewed when tapping on the extractor.
Tap the tool into the seal. Tighten the inner socket. Counter hold the outer part at the same time so that the tool expands against the seal.
Tighten the screw in the extractor. Remove the seal.
Installation
Installing the new primary shaft seal
Lubricate the lip of the primary shaft seal. Use grease, P/N 1161241-3.
Use drift 999 5727 Drift See: Tools and Equipment/999 5727 Drift when installing the primary shaft seal.
Pull the sliding drift sleeve forward. Press the seal into place.
Guide drift on primary shaft. Tap in the seal until the sliding drift sleeve is against the transmission and in the rear sleeve position.
Installing the clutch cylinder
Tighten the screws. Tighten to 10 Nm.
Thread the rubber seal onto the pipe with the boot turned towards the clutch cylinder.
Remove the protective plug. Install the junction. Always use a new quick-release connector with a rubber seal.