V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Install the mechanical cables under the heater unit on the left-hand side, down towards the hole.
Note! Be extremely careful when running the rubber bellows for the mechanical cable through the hole in the firewall. The cables must not be
damaged.
Feed the mechanical cables through the hole slightly.
Hint: Ask a colleague to hook the end of the cable onto the welding rod (wire).
Locate the grommet on the studs
Install the nuts. Tighten to 12 Nm.
Feeding in the mechanical cable from the engine compartment