V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Press down the gear selector lever in the cable duct (2) (the retaining clip will then open).
Check that the retaining clip has secured the gear selector lever in the mechanical cable by gently pulling the cable.
Apply a small amount of silicon grease (P/N 1161326) to the cut-out for the angled lever.
Align the gear selector lever and secure in the angled lever (3).
Apply a small amount of silicon grease (P/N 1161326) to the large gear selector lever ball and then install the upper ball holder.
Install the cover and the screws (4). Tighten the screws.
Installing the mechanical gearbox cable
10
Bend the mechanical gearbox cable to the left.
Install the retaining clips (5) on the sleeve. Secure the mechanical gearbox cable by the angled lever.
Ensure that the mechanical gearbox cable is securely installed.
Reinstall the side panel on the center console.
Lubricating the mountings for the top panel gear selector
11
assembly manual sport shifter
Bend each clip (x3) outward and at the same time pull each of the sides upward and over one of the clips.
Start at the inside.
Apply a small amount of silicon grease (P/N 1161326) to each clip at the side of the felt.
Caution!
Do not apply any grease to the felt.
Continue to lubricate the outside of the catches.
12
Apply a small amount of silicon grease (P/N 1161326) to the outside of the catches and to the lug.
Installing the manual gear selector assembly top panel
13