V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Remove the evaporative emission system (EVAP) valve from the air cleaner (ACL) housing (applies only to turbocharged models).
Pry the lock (yellow) until it reaches the release position. Use a screwdriver. (The lock must remain in this position during the entire installation.)
Adjusting the gear selector lever
19
Adjust the gear selector lever so that it is in the center position on the top panel gear selector assembly manual (sport shifter).
Measure the distance (A-A) from the side of the gear selector lever and out to the upper edge of the casing.
The distance must be 30 to 31 mm (1 1/4') on both sides. Press the lock into place to reassemble it after adjusting the mechanical gearbox cable.
Measure the distance once more.
Check that all gears can be easily selected.
Assemble the air cleaner (ACL) housing canister purge (CP) valve.
WARRANTY STATEMENT:
Claims may be submitted under the New Car warranty when there is a documented customer complaint, using claim type 01.
