V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Hold the pedal down. Start the engine. The pedal should travel and feel softer.
Release the brake. switch off the engine. Wait 1 minute. Then depress the pedal. The pedal should still feel soft but should become stiffer when it is
depressed several times.
There should be no leakage between the vacuum hose and the terminal at the power brake booster.
There should not be any leakage between the master cylinder and the power brake booster.
Check that the stop lamp functions.
If the stop lamp switch has been modified or changed after installation of the master cylinder and power brake booster it must be readjusted.
Pedal Position Sensor, Replacing
Pedal Position Sensor, Replacing
NOTE: The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential
information in the illustrations is always correct.
Preparatory work
Ignition off.
Press the brake pedal a few times until the pedal becomes stiff and rises slightly. This releases the vacuum in the power brake booster and thus prevents
the O-ring from being sucked in when the pedal position sensor is removed.
Removal
Removing pedal position sensor
