V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
-
the support arms on the sub-frame. Finger tighten
-
track rods on the sub-frame. Finger tighten
-
the lower control arm on the sub-frame. Finger tighten.
-
Install a M12x70 mm screw with a nut in the hole for the anti-roll bar on the control arm, as a help when measuring.
-
Check the height measurement on the control arm. If necessary adjust the height measurement with a tie strap.
-
Tighten the stub axle to the upper control arm to 50 Nm.
-
Install anti-roll bar control arms to the upper control arm. Tighten to 80 Nm.
Note: Counterhold the ball joint so as not to damage the boot.
Reinstall the sub-frame
-
Hint: Make up two centering sleeves which are then placed on the rear mountings for the sub-frame. This will make it easier to center the rear
suspension. Measured at the centering sleeves A=20mm, B=13mm, C=50mm.
Place the sub-frame on a lifting table.
-
Lift up the sub-frame enough to be able to install the EVAP canister. Tighten to 25 Nm.
-
Lift the sub-frame completely to the bodywork.
