V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Use drift 999 5117 PUNCH See: Tools and Equipment/999 5117 Punch.
Note! Drift 9995117 has been modified according to the Workshop Guide.
Installing the torque converter
Lubricate the torque converter throat with ATF oil.
Note! Take care not to damage the oil pump during installation.
Make sure torque converter is as far into the transmission as possible. Check with a ruler. The distance between the cover and retaining tabs must be
approximately 14 mm.
Installing the transmission
Install the transmission.
Sealing Ring, Crown Wheel Shaft, Left-Hand Side, Replace
Sealing ring, crown wheel shaft, left-hand side, replace
Special tools:
999 7086 Puller See: Tools and Equipment/999 7086 Puller
999 7087 Drift See: Tools and Equipment/999 7087 Drift
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information is always correct.
Preparatory work
Removing bevel gear
Remove the bevel gear.
