V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
Install the splashguard under the engine.
Right-hand side
Preparatory work
Remove the drive shaft. See Drive shaft right, replacing, B5244T5, M66 See: Axle Shaft Assembly/Service and Repair/Drive Shaft Right, Replacing.
Removing the differential seals, right-hand side
Place a container underneath the transmission.
Install the cap nut for extractor 999 5768 Puller See: Tools and Equipment/999 5768 Puller.
Lightly grease the locating pin on the extractor.
Use a ratchet with an extension and socket. Press the extractor in against the seal at the same time as the extractor is turned.
Tighten so that the threaded cone screws firmly into the seal.
-
Remove the cap nut from the extractor
-
Install the extractor bracket and nut
-
Remove the seal
-
Check that no seal residue is left.
Lubricate the edges of the new seal using automatic transmission fluid.