Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Brakes and Traction Control > Hydraulic System, Brakes > Hydraulic Control Assembly - Antilock Brakes > Component Information > Diagrams > Page 5174

Page 4
background image

Insert vacuum hose between bracket and hydraulic unit. Check that non-return valve and rubber seals are intact and in good condition. Connect
non-return valve to brake servo.

[OOOO10]

Installing hydraulic unit continued

- Connect connector to control module and pump motor.
- Remove protective plugs and connect brake pipe to hydraulic unit and master cylinder. Tighten to 14 Nm (10.3 ft lb).
- Release brake pedal.
- Install air filter casing with inlet pipe and hose to air heater.
- Connect sparkplug leads to coil.

[OOOO11]

In cars with turbo

Install:

- Intake pipe between air filter casing and turbo.

[OOOO12]

Finishing work

- Bleed braking system as per AAAA. Bleeding brakes with bleeding unit.  See: Brake Bleeding/Service and Repair

Clean up any brake fluid spillage with lukewarm water and car-wash shampoo.

[OOOO13]

Function check

Brakes and Traction Control > Hydraulic System, Brakes > Hydraulic Control Assembly - Antilock Brakes > Component Information > Diagrams > Page 5174

[PREV PAGE] [NEXT PAGE]