V70 GL L5-2.4L VIN 55 B5254S (1998)
Raise:
-
Subframe, using previously installed tools 999 5517 and 5518.
Check that the steering wheel shaft joint does not catch in the bodywork opening when raising the frame.
-
Rear of frame to half of tools' bolt length. Now repeat with front of frame.
-
Frame, until its bushings are only a few millimeters from the frame members, in the same order as above.
Note: It is important to raise the frame in the correct order, otherwise the steering wheel shaft joint will catch in the bodywork opening.
Mounting subframe
-
Position and apply a jacking unit under the LH side of the frame.
Install:
-
Support brackets and bolts, loosely.
Remove:
-
Tools 999 5517 and 5518.
Install:
-
Subframe bolts.
Note: Be careful of the washer on the front bolt. Use new bolts (4 x M14).Grease bolt threads.