Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Brakes and Traction Control > Sensors and Switches - Brakes and Traction Control > Wheel Speed Sensor > Component Information > Service and Repair > Front Wheel Sensor [KKKK] > Page 5386

Page 6
background image

Pull the heat-shrink tubing over the cable splices.

Heat with a hot air gun to seal the heat-shrink tubing at both ends. 
The new, spliced cable harness should be routed down to the wheel sensor in the same way as the old to avoid damage caused by rubbing Secure the
new cable harness in the same way as the old one. 
Reinstall wheel. 
Tighten wheel nuts alternately to 110 Nm.

Checking ABS system

After repairs are complete it is important to check the ABS system.
-

Ignition off.

-

Connect adapter 951 1354 to control module connector on wiring side (see illustration)

-

Connect breakout box. 981 3190 to adapter.

-

Control module disconnected.

Brakes and Traction Control > Sensors and Switches - Brakes and Traction Control > Wheel Speed Sensor > Component Information > Service and Repair > Front Wheel Sensor [KKKK] > Page 5386

[PREV PAGE] [NEXT PAGE]