Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Engine, Cooling and Exhaust > Engine > Camshaft, Lifters and Push Rods > Camshaft Gear/Sprocket > Component Information > Service and Repair > With Mechanical Adjuster > Page 1770

Page 4
background image

Tighten the camshaft pulley screws tighten to 20 Nm 
Remove the camshaft locking tool (999 5452) from the rear edge of the camshafts.
Remove crankshaft locking tool 999 5451 (Install plug).
Install timing cover.
Turn the crankshaft two revolutions and check that the markings correspond.

Install 

-

front timing cover

-

expansion tank

-

two fuel lines clamps

Install 

-

Camshaft Position (CMP) sensor housing with damper

-

rotor and distributor cover

-

Air Cleaner (ACL) housing, with hoses

-

spark plugs cover

-

starter motor

-

engine Cooling Fan (FC)

-

fender liner and wheel

Test function 

Test run engine.

Engine, Cooling and Exhaust > Engine > Camshaft, Lifters and Push Rods > Camshaft Gear/Sprocket > Component Information > Service and Repair > With Mechanical Adjuster > Page 1770

[PREV PAGE] [NEXT PAGE]