Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Engine, Cooling and Exhaust > Engine > Cylinder Block Assembly > Connecting Rod, Engine > Component Information > Service and Repair > Crank, Pistons and Rods, Dismantling > Page 1810

Page 6
background image

14. Press in new bushing: 

-

Use drift tool No. 999 5309, or equivalent. 

-

Use drift the right way round, with long end downwards. 

-

Push drift right down.

NOTE:  Make sure that hole in bushing lines up with lubricating passage in connecting rod.

15. Check wrist pin fit in new bushing:

-

Wrist pin should slide through bushing without noticeable play when pressed gently with thumb.

-

Adjust bushing as required.

16. Check connecting rod in alignment gauge: 

-

Check for straightness and twisting.

NOTE:
-

Check that clamping surface of fork is round and free of burrs. 

-

Release and tighten expander at big end between each alignment check.

17. Connecting Rods, replacement:

-

Connecting Rods are symmetrical and can be turned over if required.

Engine, Cooling and Exhaust > Engine > Cylinder Block Assembly > Connecting Rod, Engine > Component Information > Service and Repair > Crank, Pistons and Rods, Dismantling > Page 1810

[PREV PAGE] [NEXT PAGE]