Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Engine, Cooling and Exhaust > Engine > Cylinder Block Assembly > Expansion/Freeze Plug > Component Information > Technical Service Bulletins > Engine - Cylinder Block Seal Plug Installation > Page 1856

Page 7
background image

Installing heated oxygen sensors (HO2S)

Install:

-

the heat deflector plate

-

the heated oxygen sensors (HO2S). Use tool 999 5543, Socket NV -22. Tighten to 45Nm

-

the bracket for the right-hand heated oxygen sensor (HO2S) cable

-

the tie strap holding the wiring for the heated oxygen sensors (HO2S) to the transmission dipstick

-

the preheating pipe.

15

Installing the crossmember

Install:

-

the engine stabilizer brace. Tighten the four screws on the suspension turrets. Tighten to 50Nm.Tighten the screw in the torque bracket. Tighten to
80Nm

-

the servo hose to the engine stabilizer brace using a tie strap.

16

Installing the exhaust system

Engine, Cooling and Exhaust > Engine > Cylinder Block Assembly > Expansion/Freeze Plug > Component Information > Technical Service Bulletins > Engine - Cylinder Block Seal Plug Installation > Page 1856

[PREV PAGE] [NEXT PAGE]