V70 GL L5-2.4L VIN 55 B5254S (1998)
14. Press in new bushing:
-
Use drift tool No. 999 5309, or equivalent.
-
Use drift the right way round, with long end downwards.
-
Push drift right down.
NOTE: Make sure that hole in bushing lines up with lubricating passage in connecting rod.
15. Check wrist pin fit in new bushing:
-
Wrist pin should slide through bushing without noticeable play when pressed gently with thumb.
-
Adjust bushing as required.
16. Check connecting rod in alignment gauge:
-
Check for straightness and twisting.
NOTE:
-
Check that clamping surface of fork is round and free of burrs.
-
Release and tighten expander at big end between each alignment check.
17. Connecting Rods, replacement:
-
Connecting Rods are symmetrical and can be turned over if required.