Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Engine, Cooling and Exhaust > Engine > Drive Belts, Mounts, Brackets and Accessories > Drive Belt > Component Information > Service and Repair > Replacing the Auxiliaries Belt / Belt Tensioner

Page 1
background image

Drive Belt: Service and Repair
Replacing the Auxiliaries Belt / Belt Tensioner

Auxiliaries belt/belt tensioner, replacing 

Note!

As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information in the illustrations is always correct.

Removal

Removing the auxiliaries belt 

Remove:

-

the plastic cover on the blet tensioner using a small screwdriver. Use a wrench and turn clockwise as far as possible to relieve the load on the belt.

-

the belt.

 
Replacing the belt tensioner 

Remove:

-

both mounting screws from the auxiliaries belt bracket for the belt tensioner.

-

the belt tensioner. Install the new belt tensioner. Tighten to 25 Nm (18.4 ft lb)

Installation

Installing the auxiliaries belt

Caution!

Ensure that the belt is correctly seated in all the grooves on each pulley

Engine, Cooling and Exhaust > Engine > Drive Belts, Mounts, Brackets and Accessories > Drive Belt > Component Information > Service and Repair > Replacing the Auxiliaries Belt / Belt Tensioner

[PREV PAGE] [NEXT PAGE]