Volvo Workshop Manuals
V70 GL L5-2.4L VIN 55 B5254S (1998)
Engine, Cooling and Exhaust > Engine > Timing Components > Timing Belt > Component Information > Service and Repair > Replacement, W/Mechanical Tensioner > Page 2068
Check tensioner and idler pulleys:
Spin the pulleys and listen for noise in the bearings.
Pulley, tighten to: 30 Nm (22 ft lb)
Adjusting the mechanical belt tensioner
If a mechanical belt tensioner is being used, adjust according to "Adjusting the Mechanical Belt Tensioner" See: Timing Belt Tensioner/Adjustments
Lock tensioner damping unit
Check there there is no visible leakage.
If there is leakage or no resistance when pushed in or if it cannot be pushed in the tensioner damping unit must be replaced.
Install the new timing belt
Install tensioner damping unit torque to 25 Nm (18 ft lbs).
Installing camshaft pulley and timing belt
The timing belt must be installed correctly to obtain the correct timing. Before tightening the screws between the camshaft and
|[PREV PAGE] [NEXT PAGE]|