V70 GL L5-2.4L VIN 55 B5254S (1998)
Wheel Bearing: Testing and Inspection
Measuring lateral run-out in hub
Special tools:
999 5418
999 5507
Preparations
-
Get measurement tool set 999 5418.
-
Remove brake caliper and brake pads as per Brake disc front, replacement or Brake disc rear, replacement. Then continue as below.
Note: Mark brake disc up against hub so disc can return to its old position when installing.
-
Clean hub flange carefully. Remove rust with steel blade and steel brush.
Installing measurement equipment
-
Install measurement equipment as per illustration. Illustration shows testing front.
-
Front:Use Me bolts, washers and nuts in bolt set 999 5507 when installing measurement tool bracket to front brake caliper mounting hole.
Note: Make sure that bracket is not lying against driveshaft gaiter, (front only).
-
Rear:Use the bolts included in the measurement tool set when installing measurement tool bracket to the rear brake caliper mounting hole.
Measuring lateral run-out