Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70 GL L5-2.4L VIN 55 B5254S (1998)

Powertrain Management > Fuel Delivery and Air Induction > Fuel Tank > Fuel Gauge Sender > Component Information > Technical Service Bulletins > Fuel Sending Unit - Installation > Page 3716

Page 3
background image

Before removing old sending unit, place gauge as per illustration.

Place a piece of masking tape on the floor board, under the aim tab.

Make two lines on the tape, using the two slits on the tab as template.

3

Harness

Separate the connector for the sending unit.

Move the harness from the sender over to the right side of the vehicle.

Attach a string or similar to the connector as per illustration.

Carefully pull over the harness with the connector to the access hole of the sending unit.

Note!

Place the string so that the harness of the new sending unit can be pulled back over again.

4

Remove fuel sending unit

Powertrain Management > Fuel Delivery and Air Induction > Fuel Tank > Fuel Gauge Sender > Component Information > Technical Service Bulletins > Fuel Sending Unit - Installation > Page 3716

[PREV PAGE] [NEXT PAGE]